Good Nite Lite Instructions

Use ON/OFF switch on back of unit to turn ON your Good Nite Lite. 

To Set the Current Time:

1. Press, hold (for 2 seconds) and release the right/set button.  Your screen will illuminate brightly and display the default time of 10AM* (default times may vary on some models). 
   
   
2. Press and hold the left/select button until the time flashes.  Use the toggle/mode switch to adjust the time up and down for the minutes and then for the hours.   Use the left/select button to move between hours and minutes. 
   
   
3. Once the current time appears on the screen, press and hold the left/select button until the numbers stop flashing to “set” your time.
   
   --------------------------------------------------------------------------------------------------------> Then

To Set the Sleep Time (time you would like the moon to illuminate):

1. Push and hold down the toggle/mode lever until you see the moon icon and the default sleep time of 7PM* blinking on the screen.
   
   
2. Use the toggle/mode switch to adjust the time up and down for the minutes and then for the hours.   Use the left/select button to move between hours and minutes.
   
   
3. Once your Sleep Time appears on the screen, press and hold the left/select button until the current time appears.  Your Sleep Time is set.
   
   ---------------------------------------------------------------------------------------------------------> And now

To Set the Wake-Up Time (time you would like the sun to illuminate):

1. Push and hold up the toggle/mode level until you see the sun icon and the default wake time of 7AM* blinking on the screen.
   
   
2. Use the toggle/mode switch to adjust the time up and down for the minutes and then for the hours.   Use the left/select button to move between hours and minutes.
   
   
3. Once your Wake-Up Time appears on the screen, press and hold the left/select button until the current time appears.  Your Wake-Up Time is set.
   
   -----------------------------------------------------------------------------------------------------------> Ready!

Once you have the three times programmed, plug your light into the outlet.
If at any time you unplug the light and turn the switch to the “off” position your light will revert to the factory settings and you will need to reset your personalized times.

* The Default time may vary on some models

*   Your backlight only illuminates for a few seconds before you need to start to set your clock.  If the screen darkens, press/hold/release the right button once again to “wake” the timer.